Your tasked to create a pre-tender estimate of the cost to produce and deliver the ‘LTU Sw
Your tasked to create a pre-tender estimate of the cost to produce and deliver the ‘LTU Swiper’.A diagram is shown in the appendix. The LTU Swiper is a handy household item for cleaningwindows. The part is to be made using plastic injection moulding using a technique known as2K. 2K moulding enables the use of more than one plastic to be injected into the same mould.In this particular the case the LTU Swiper handle is to be made from Polypropleyene (PP) andthe Blade from Ethylene Propylene Diene Monomer (EPDM). The intended market for thisproduct is the Asia-pacific market with a distribution centre located in Bundoora, Australia.Quantities may vary dependent on market demand. Initial estimates are that this will be a100,000 units. The time for delivery is 45 days from order placement. You are provided withbill of quantities prepared separately, priced and submitted by 3 different producers locatedlocally in Australia, and overseas in New Zealand and China.